3d Printed Govee Mounting Clips are available for Govee Pro, Govee Outdoor Lights 2, Govee Standard, Govee Elite, and other outdoor light styles. They are made with PETG plastic which is suitable for outdoor use, and the clips are not hollow (they are printed at 100% infill).

• Govee Pro

  • Sets have 30 lights per 50 feet, and mounting clips are $22 per 30 clips.

• Govee Standard (Includes Govee Elite and Govee Outdoor Lights 2)

  • Sets have 36 lights per 50 feet, and mounting clips are $26 per 36 clips.

• Installation Tool

  • Orders include an installation tool. Our default spacing from the face of the home to the inside edge of the light is 3.5 inches, but different spacing may be provided upon request. For more information click here.

• Peak Adapters

  • Shown on the Home page, peak adapters are $5 each. It pairs with one of the Mounting Clips to ensure a level install at the peak of an eave.

• Screws

  • #6 stainless screws, 1 inch long. They can be included at $6 per 100 Screws, provided supplies are available (These are often sold out). Newfoundland Distributors usually has good pricing on these, but they sell out often. #8 screws can also be used, but may be a bit snug.

Please note that printed items can have minor defects. Mounting Clips are printed with tight tolerances to ensure a snug fit on the lights, but they should not require nearly enough force to damage your lights. If you cannot get the mounting clip around the light while using a safe and moderate amount of force, do not use that clip. Put any unacceptable clips aside for exchange. Extra clips are provided with each order, but if you need more please reach out.